ENGLISH
12
RESOLVING MALFUNCTIONS
Problem Resolution
1
Measurements on the
remote sensor and the
receiver do not match
Wait for 1-2 minutes so that the remote sensor
and the receiver can become synchronized. Sec-
ond option: re-synchronize the remote sensor
and receiver by pressing and holding the Chan-
nel button for 3 seconds, until an audible signal
is heard.
2
Temperature from the
external temperature
sensor seems elevated
Make sure that the sensor is not exposed to direct
sunlight; the sensor should not be near any heat
sources.
3
The receiver has
stopped receiving data
from remote sensors
and displaying this data
on the LCD
- Repeat the detection function.
- Maybe the temperature is less than -30°C
- The batteries need to be changed in the re-
mote sensor
- Move the remote sensor closer to the receiver
- Make sure the remote sensor is not located
near sources of radio interference.
4
The device is not work-
ing properly or is not
completing certain
functions
The device must be reinstalled. Reinstall the de-
vice by changing the batteries in the receiver and
the remote sensor
35391.indd 1235391.indd 12 23.05.2006 17:08:5223.05.2006 17:08:52
To Next Page
Loading...
