EasyManua.ls Logo

Vitek VT-6402 BK - Remote Temperature Sensor; Safety Precautions

Vitek VT-6402 BK
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
5
Remote temperature sensor
1. LED
. Batterycompartmentcover(twobatteriesof“ААA”type(1,5В)).
. SensorresetbuttonafterchangingchannelnumberТх
. ButtonforwitchingbetweenFahrenheit/CelsiusscalesC/F
5. Channelswitcher(1--)
6. Openingformountingtheunitonawall
Safety Precautions
1. Readthisoperationmanualcarefullybeforeyoustartusingthese
appliances.
. Donotimmersetheseappliancesintowater.
. Donotuseabrasivechemicalsforcleaningtheseappliances,astheycould
causehousingandinternalpartsdamage.
. Donotexposetheseappliancestostrongphysicalimpactsandstrikes
(dustandmoisturearedangeroustoo)astheymaycausemalfunctions,
shortentimeofservice,batterydamage,andhousingdetailsdeformation
asresult.
5. Donotdisassemblethisunit,doingsoleadstowarrantycancellation.There
arenoserviceablepartsinsidedemandinguser’sattention.
6. Usenewbatteriesonly,meetingthespecificationsofoperatingmanual
exactly.Donotinstalloldandnewbatteriesatthesametime.
7. UseonlyACadapterincludedintodeliveryset.
Before you begin
Installremotesensorwithintherangeofeffectivedatatransfer,asclosetobasic
blockaspossible.Locatebasicandremotesensorsatplaceswheretheinterfer-
enceisminimaltoprovidethebestdatatransmission.Takeintoaccountthat
datatransferrangeofremotesensordependsuponconstructionalmaterialof
partitionwallsandtheirnumberintheroom.Tryseveralvariantsofinstallation.
Inspiteofthefactthatremotesensorisprotectedagainstnegativeweatheritis
requiredtoinstallitthustoavoidexposuretodirectsunradiation,rainorsnow.
Householdappliances(doorbell,signaling,etc)maycreateinterferencewhile
receivingsignalfromsensorbythemainblock.Thisisnormal,andthisdoesn’t
influenceonthegeneralperformanceoftheappliances.Signalreceivesand
datatransferwouldberesumedimmediatelyaftertemporaryinterferenceis
over.
6402IM.indd 5 11.04.2008 16:37:16

Related product manuals