EasyManua.ls Logo

Vitek VT-6402 BK - Replacing Batteries; Get Started

Vitek VT-6402 BK
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
6
Installation of batteries into remote sensor
1. Turnoffthescrewsonthebatteriescompartment.
. Selectdatatransferchannelbychannelsswitcher«1--».
. Installbatteries(“ААА”,1.5V),followingpolarity.
. Closebatterycompartmentcoverandturnupthescrews.
ConnectingAC-poweradaptertobasicblock/Installationofbatteriesinto
basicblock. ConnectAC-poweradapter(,5V;DC)tobasicblock
throughthejackforanexternalpowersourcelocatedbelowthebatteries
compartment.
or
. Openthecoverofbatteriescompartment.
. Installthreebatteries(“AАА”,1.5V),followingpolarity.
. Closebatterycompartmentcover.
Note:
Basicblockisintendedforpowersupplyfromexternalsource,batteriesare
usedasreservepowersource.ContinuousLCDbacklight,andcontinuouspro-
jectionoftimeispossibleonlyincaseofconnectiontoexternalpowersource
throughACadapter.
Replacing Batteries
Onappearanceofadequateiconindicationsdisplayingthatthebatteriesare
downreplaceremotesensorbatteries.
Get Started
Byfirststartup,switchmainblockon,andswitchonremotesensor.Setdata
transferchannelbychannelswitcher«1--»locatedonremotesensor.Hold
buttonCHANNELonmainblock,youwillhearsoundsignal.Mainblockstarts
searchingremotesensorsignal.PressbuttonТхtoresetthesensor.Whencon-
nectionbetweensensorandmainblockisseton,temperatureindicationsfrom
remotesensorwillappearonLCD.
Setting pressure parameters by switching on the unit first time
1. Afterconnectingbasicblocktopowersupplylinepressureunits’iconstarts
blinking.Usebuttons«/»toselectpressureunits,inHg,hPa,mBaror
mmHg.PressbuttonPRESSUREforconfirmation.
. Usebuttons«/»tosetthevalueofaltitudeabovesealevel.Press
buttonPRESSUREforconfirmation.
Settingpressureparametersviafirststartupisimperativeforprecise
weatherforecast.
6402IM.indd 6 11.04.2008 16:37:16

Related product manuals