Vitek VT-6402 BK - Page 8

English
8
Temperature indications
Basicblockisablereceivingdatafromtreeremotesensors,eachofthemhas
eachownchannelfortemperaturedatatransmission.CentigradeorFahrenheit
degreecanbeselectedastemperatureunits.UseC/Ftoselecttemperature
units.
Switching between data receiving channels
PressbuttonCHANNELtoswitchbetweenremotesensors’datareceivingchan-
nels(Ch1,Ch,Ch),indoors(IN),switchingbetweendifferentchannels’
temperaturedataindication( )incycle.
Temperature trends
Temperaturetrendsaredisplayedbyarrows(increasing,decreasing)nearthe
adequatedata.
Viewing minimal/maximal value of temperature
EachpressingonbuttonMEMORYswitchesbetweenthenextparameters’indi-
cation:
• Currenttemperature
• Minimaltemperature
• Maximaltemperature
Minimal/maximal temperature values reset
PressandholdbuttonMEMORYforsecondstoclearallchannels’memories.
Notice: Remotesensorbatteriesvoltagemaydecreasewhileoperatingattem-
peraturebelow0°C,thusremotesensorrangeofactionwouldbeshortenedtoo.
Setting date and current time
Basicblockisableviewingcurrenttimeanddate.PressbuttonCLOCKtoswitch
betweencurrenttime,dateanddayofweek.
PressandholdbuttonCLOCKforsecondstosetcurrenttimeanddate.You
canchoosetimeindicationformat(1hoursorhours)anddateformat(day/
monthormonth/day),setcurrenttime(hours,minutes)anddate.
Usebuttons«▼/▲»toinputparameters.PressbuttonCLOCKforconfirmation.
Setting alarm
PressbuttonALARMtoswitchonalarmmode.Symbol«AL»appearsonLCD.
PressthisbuttononcemoretoswitchalarmON/OFF,whenalarmisonsymbol
isonLCD.
6402IM.indd 8 11.04.2008 16:37:16