Using the Power Analyzer 71
When the highlighted cursor is in the correct position, use the UP or
DOWN ARROW keys to change the highlighted number or symbol
Press the ENTER key when finished.
Note: You can press the CLEAR (F3) key to start over, or clear the
screen.
Press the MENU key to exit back to the MEASUREMENT
CONFIGURATION menu, or keep pressing the MENU key to exit
back to the main display screens.
Setting Up the Ch2 Measurement Configuration (2802
Only)
There are four selections in the Ch2 MEASUREMENT CONFIGURATION
menu. The following section defines each of the selections and the associated
submenu options available. Refer to the arrow on the side of this display and
scroll this menu down to access each one:
RESULTS AVERAGING:
MEASUREMENT TYPE:
RANGING AND SCALING…
WIRING ADJUSTMENTS…
The configuration of these menus are identical to the methods described in the
section for Configuring the Analyzer’s Measurement Results.
Setup System
Access the SETUP SYSTEM MENU from the MAIN MENU. Press ENTER
at highlighted item to access.
To Next Page
