Clock
When you push the OK button, the clock time
display stops flashing and the clock starts
operating.
Push the CLOCK button in the battery compartment,
the colon in the clock display will start to flash.
To set the new time, follow 1 and 2 of "Initial Setting
of the Clock".
1. When you push the LOCK button, all
current settings are locked in and the
remote controller does not accept any
operation except that of the LOCK button
Use the lock mode when you want to
prevent settings from being changed
accidentally or playfully.
Push the LOCK button again when you
want to cancel the LOCK mode.
AIR
DIRECTION
SWING
OK
CLOCK
TIME ADJUST
2
1
CANCEL
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
2. When you push the RESET button,
all current settings are cancelled and get
into the condition of beginning.
In the clock, the colon in "0:00" will flash,
the mode displays "Auto", fan speed
displays "Auto", the temperature displays
"24".
* Clock accuracy is within 10 seconds per day.
2.OK button.
3.Readjusting the Clock
Static electricity or other factors (in case of extremely high voltage) can cause remote
controller clock initialise. If your remote controller is initialized (flashing of the colon in
"0:00"), readjust the clock before you start operation.
CAUTIONS
LOCK AND RESET BUTTON FUNCTION
6
To Next Page
Loading...
Need help?
General
