ENG VIVAX
25
Handling the remote controller
Location of the remote controller.
Use the remote controller within a
distance of 8 meters from the
appliance, pointing it towards the
receiver. Reception is confirmed
by a beep.
CAUTIONS
• The air conditioner will not
operate if curtains, doors or
other materials block the
signals from the remote
controller to the indoor unit.
• Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer..
Replacing batteries
The remote controller is powed by two
dry batteries(R03/LR03X2) housed in
the rear part and protected by a cover.
(1) Remove the cover by pressing and
sliding off.
(2) Remove the old batteries and insert
the new batteries,placing the(+) and
(-) ends correctly.
(3) Reattach the cover by sliding it back
into position.
NOTE: When the batteries are removed, the. remote controller erases all
settings.
After inserting new batteries, the remote controller must be reprogrammed.