ENG VIVAX
35
Installation in a double-hung sash window
1. Cut the foam seal(adhesive type) to the proper length and attach it to the
window stool. Fig.8
2. Attach the window slider kit to the window stool. Adjust the length of the
window slider kit according to the width of window, shorten the adjustable
window kit if the width of window is less than 26.5 inches
Open the window sash and place the window slider kit on the window stool.
Fig.9
3. Cut the foam seal(adhesive type) to the proper length and attach it on the
top of the window. Shown as in Fig.10
4. Close the window sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap between
the top window sash and outer window sash. Shown as in Fig.11.
(adhesive type)