Initial Camcorder Setup
POWERING THE CAMERA ON
Battery
Make sure the built-in lithium battery has been fully charged before using your camcorder.
To charge the battery using the supplied USB connection cable and your computer follow these
instructions:
1. Power off the camcorder.
2. Connect the smaller end of the USB cable into the USB slot on your camcorder.
3. Connect the other end of the USB cable to the USB port on your computer. (See figure 2)
4. The LCD screen will show ‘ON’.
The battery icons will flicker while charging is in progress. (See figure 3)
5. The full battery icon will display on the LCD when the camera is fully charged.
To Next Page
Loading...
