To Next PageTo Next Page
Need help?Do you have a question about the Vivo Blue Kids DESK-V303B and is the answer not in the manual?
General| Brand | Vivo |
|---|---|
| Model | Blue Kids DESK-V303B |
| Category | Indoor Furnishing |
| Language | English |
Adjust chair legs to equal length and place in feet, ensuring they are fully seated.
Secure chair feet using M6x20 screws and lock washers with an Allen wrench.
Assemble the right side support bar to the leg using screws and plastic washers.
Slide center and left support bars onto the right bar and secure to legs.
Mount the plastic seat bottom to the chair frame using screws and a Phillips screwdriver.
Slide the plastic seat back onto the chair frame, aligning holes for height.
Secure the seat back to the chair frame using knobs.
Adjust chair feet to ensure the chair sits level on the floor.
Adjust desk legs to equal length and place in feet, ensuring they are fully seated.
Secure the desk feet using M6x20 screws, lock washers, and an Allen wrench.
Assemble the desktop to the legs using M6x45 screws and plastic washers.
Fit the hook into the slot on the left or right side of the desk.
Place the LED lamp into the desktop hole and connect the power adapter.
Loosen knobs to adjust desktop tilt angle and tighten to secure the position.
Step on the support bar and pull up evenly on both sides to reach desired height.
Step on the support bar, pull up, then slowly lower to the desired height.
