Vivotek FD8166A-N - Page 182

VIVOTEK
182 - User's Manual
7.10 IR cut control
Group: ircutcontrol
(capability.nvideoinprofile> 0 and capability_daynight_c<0~(n-1)>_ircutfilter=1)
n denotes the value of "capability_nvideoin"
NAME VALUE SECURITY
(get/set)
DESCRIPTION
mode auto,
day,
night,
di,
schedule
<product
dependent>
6/6 Set IR cut control mode
sir
<product dependent>
<boolean> 6/6 Enable/disable Smart IR
* Only available when
"capability_daynight_c<0~"capability_nvide
oin"-1>_smartir" is 1
daymodebegintime 00:00~23:59 6/6 Day mode begin time
daymodeendtime 00:00~23:59 6/6 Day mod end time
disableirled <boolean> 6/6 Enable/disable built-in IR led
(capability_daynight_c<0~"capability_nvide
oin"-1>_buildinir > 0)
enableextled <boolean> 1/6 Enable/disable external IR led
(capability_daynight_c<0~"capability_nvide
oin"-1>externalir > 0)
bwmode <boolean> 6/6 Switch to B/W in night mode if enabled
sensitivity low, normal, high
(if
capability_daynight
_c<n>_ircutsensitiv
ity_type=options)
1~100 (if
capability_daynight
_c<n>_ircutsensitiv
ity_type=normalize
)
6/6 Sensitivity of day/night control.
There are two value format:
"low,normal,high": if
capability_daynight_c<n>_ircutsensitivity_t
ype=options
"1~100": if
capability_daynight_c<n>_ircutsensitivity_t
ype=normalize
* Only available when
"capability_daynight_c<n>