Vivotek FD8166A-N - Page 186

VIVOTEK
186 - User's Manual
<product dependent> 0: disable
1: enable
* Only available when
"capability_image_c<n>_scenemode_suppor
t" is 1
scene_mode
<product dependent>
visibility,
noiseless,
lpcparkinglot,
lpcstreet
<product
dependent>
4/4 Value of scene mode
* Only available when
"capability_image_c<n>_scenemode_suppor
t" is 1
* Available value is listed in
"capability_image_c<n>_scenemode_suppor
ttype"
restoreatwb
1~
4/4 Restore of adjusting white balance of image
according to mode settings
freeze
<product dependent>
<boolean> 4/4 Enable/disable Image freeze while patrolling.
0: disable
1: enable
* Only available when
"capability_image_c<n>_freeze" is 1
profile_i<0~(m-1)>_enable <boolean> 4/4 Enable/disable this profile setting
profile_i<0~(m-1)>_policy night,
schedule
4/4 The mode which the profile is applied to.
* Not support "policy=day" anymore when the
version number (httpversion) is equal or
greater than 0301a.
profile_i<0~(m-1)>_begintime hh:mm 4/4 Begin time of schedule mode.
profile_i<0~(m-1)>_endtime hh:mm 4/4 End time of schedule mode.
profile_i<0~(m-1)>_brightness
<Not recommended to use this>
-5~5,100 4/4 -5: Darker <-> 5: Bright
100: Use " image_c<n>_brightnesspercent"
* Only available when bit 0 of
"capability_image_c<n>_basicsetting" is 1
* We replace "profile_i0_brightness" with
"profile_i0_brightnesspercent".
* This parameter will not be used after the
version number (httpversion) is equal or
greater than 0400a.
profile_i<0~(m-1)>_contrast
<Not recommended to use this>
-5~5,100 4/4 -5: Less contrast <-> 5: More contrast
100: Use " image_c<n>_contrastpercent"