Vivotek FD8369A - Page 212

VIVOTEK
212 - User's Manual
channel, bit 10~19 are the 2nd group for 2nd
channel, bit 20~31 are the 3rd group for 3rd
channel.
Then, the 1st bit of the group indicates 1st
stream of a channel support ePTZ or not. The
2nd bit of the group indicates 2nd stream of a
channel support ePTZ or not, and so on.
* For most products, the last stream of a
channel will not support ePTZ. It is reserved
for full view of the channel. For some
dual-stream products, both streams support
ePTZ.
nanystream 0, <positive
integer>
0/7 number of any media stream per channel
iva <boolean> 0/7 Indicate whether to support Intelligent Video
analysis
whitelight <boolean> 0/7 Indicate whether to support white light led.
iris <boolean> 0/7 Indicate whether to support iris control.
supportsd <boolean> 0/7 Indicate whether to support local storage.
fisheye <boolean> 0/7 The parameter is used to determine whether
the product is fisheye or not.
tampering <boolean> 0/7 Indicate whether to support tampering
detection.
tamperingmode tamper,toodark,toob
right,tooblurry
0/7 Available tampering mode list.
* Only available when "capability_tampering"
is 1.
adaptiverecording <boolean> 0/7 Indicate whether to support adaptive
recording.
adaptivestreaming <boolean> 0/7 Indicate whether to support adaptive
streaming.
supporttriggertypes seq,boot,motion,net
workfail,recnotify,ta
mpering,vi,vadp,di,
volalarm,temperatu
re,pir, visignal,
backup
<product
dependent>
0/7 list all the trigger types which are supported in
the camera:
"seq" = Periodic condition
"boot" = System boot
"motion" = Video motion detection
"networkfail" = network connection failure
"recnotify" = Recording notification.
"tampering" = Tamper detection.