Vivotek IB8360 - Page 188

VIVOTEK
188 - User's Manual
deinterlace_mode spatial,blend 4/4 Users can choose between two different
deinterlacing techniques:
Spatical mode provides the best image quality,
while Blend mode provides better image
quality (than not using the deinterlace function
at all).
* Only available when
"capability_image_c<0~(n-1)>_deinterlace_s
upport" is 1.
xoffset 0~100 4/4 Adjusting the image to proper position
horizontally.
* Only available when the bit 4 of
capability_image_c<0~(n-1)>_basicsetting is
1.
yoffset 0~100 4/4 Adjusting the image to proper position
vertically.
* Only available when the bit 5 of
capability_image_c<0~(n-1)>_basicsetting is
1.
profile_i<0~(m-1)>_enable <boolean> 4/4 Enable/disable this profile setting
profile_i<0~(m-1)>_policy night,
schedule
4/4 The mode which the profile is applied to.
* Not support "policy=day" anymore when the
version number (httpversion) is equal or
greater than 0301a.
profile_i<0~(m-1)>_begintime hh:mm 4/4 Begin time of schedule mode.
profile_i<0~(m-1)>_endtime hh:mm 4/4 End time of schedule mode.
profile_i<0~(m-1)>_brightness
<Not recommended to use this>
-5~5,100 4/4 -5: Darker <-> 5: Bright
100: Use "
image_c<0~(n-1)>_brightnesspercent"
* Only available when bit 0 of
"capability_image_c<0~(n-1)>_basicsetting"
is 1
* We replace "profile_i0_brightness" with
"profile_i0_brightnesspercent".
* This parameter will not be used after the
version number (httpversion) is equal or
greater than 0400a.