VIVOTEK
8 - User's Manual
3. Find an appropriate position. Drill holes on the wall for the included plastic anchors.
Install the camera by driving screws through the mounting holes on the bracket. The
anchors may not be necessary if you install the camera on a wooden wall or calcium
silicate board. If preferred, drill a routing hole on the wall for routing the Ethernet cable.
If you need to route cables along the wall, use a pincer to remove the break-off tabs.
< 10 kgf-cm
4. Loosen the fastening ring on the mount bracket, and then adjust the camera's shooting
direction.
To Next Page
Loading...
