Vivotek IB8367A - Page 225

VIVOTEK
User's Manual - 225
buildinpt <boolean> 0/7 An 32-bit integer, each bit can be set separately
as follows:
Bit 0 => support build-in pan
Bit 1 => support build-in tilt
zoommodule <boolean> 0/7 Indicate whether to support zoom lens. In our
product, only SD series and IZ series use the
zoom lens.
* Both varifocal and zoom lenses are built with
movable elements that permit changing the
effective focal length. And the key difference
between a varifocal and a zoom lens can be
explained by thinking about a lens that has been
focused on an object at any focal length. A
varifocal will need to be refocused whenever the
focal length is adjusted; the zoom will stay in
focus when the focal length is adjusted.
Group: capability_ptz_c<0~(n-1)> n denotes the value of "capability_nvideoin"
(capability_ptzenabled > 0 and capability_camctrl_c<0~(n-1)>_zoommodule !=0)
* We support this group when the version number (httpversion) is equal or greater than 0303b.
PARAMETER VALUE SECURITY
(get/set)
DESCRIPTION
panspeedlv 0, <positive integer> 0/7 The maximum speed level of pan motion.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
minpan 0, <positive integer> 0/7 The lower limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxpan 0, <positive integer> 0/7 The upper limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
minpanangle <integer> 0/7 The lower limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"