Vivotek IP8130W - Wireless Connection: Using the WPS Button

VIVOTEK
User's Manual - 19
WPS
WPS
1� Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected
Setup) functions� WPS enables easy setup with compatible APs�
2. Disconnect your LAN cable, and connect the power cord.
3� Wait for 1 minute for the camera to boot up� Press the WPS button for 1 second� The
front panel LED should blink blue�
4� Press and hold down the WPS button on your AP (some router/AP
will have a virtual button on their management software instead)�
Refer to your AP's documentation for details using its WPS
functions�
When WPS conguration is done, wireless connectivity will be established and the
security encryption, such as WEP or WPA-PSK, will be synchronized with the AP.
Use the IW2 utility to nd the camera. As for IP setting, the camera's use of DHCP or
static IP is determined by your conguration on the network camera via the web-based
conguration of rmware. The camera's default is DHCP.
NOTE:
WPS Button
WPS Button
Wireless AP
1� It is strongly recommended to apply WPA2/AES encryption for access security�
2. WPS may not work if your AP is congured with a "hidden" SSID.
3. If no WPS-enabled AP is detected, and if the camera still can not detect an AP after 2
minutes, the wireless setup will be cancelled. If WPS conguration should fail, wireless
conguration will be cleared. You can then re-try the process above or use a wired
connection to establish a web console and manually congure the wireless settings.
4. If a camera is assigned with a xed IP outside the AP's network segment, wireless setup
will fail�
5. A wired connection always has a higher priority, and hence wireless setup will not take
effect when the RJ45 LAN port is connected� If you want to switch from wired connection
to wireless connection, disconnect the Ethernet cable and reboot the camera.
Wireless Connection: Using the WPS Button