Vivotek IP8361 - Page 141

VIVOTEK
User's Manual - 141
2-2
uartmode rs485,
rs232
4/4 RS485 or RS232.
uartreset <boolean> 4/4 Set the flag to true to apply change in UART
configuration.
customdrvcmd_i<
0~9>
string[128] 1/4 PTZ command for custom camera.
speedlink_i<0~4>
_name
string[40] 1/4 Additional PTZ command name.
speedlink_i<0~4>
_cmd
string[128] 1/4 Additional PTZ command list.
updatecustomdrvc
md
1 7/4 Set this flag to true to apply change in custom command
configuration.
updatespeedlinkc
md
1 7/4 Set this flag to true to apply change in additional PTZ
command configuration.
ptzdriver 0~19,
127(custom)
,128(no
driver)
4/4 The PTZ driver is used by this COM port.
Group: snmp (capability.snmp) (product dependent)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
v2 0~1 6/6 SNMP v2 enabled. 0 for disable, 1 for enable
v3 0~1 6/6 SNMP v3 enabled. 0 for disable, 1 for enable
secnamerw string[31] 6/6 Read/write security name
secnamero string[31] 6/6 Read only security name
authpwrw string[8~128] 6/6 Read/write authentication password
authpwro string[8~128] 6/6 Read only authentication password
authtyperw MD5,SHA 6/6 Read/write authentication type
authtypero MD5,SHA 6/6 Read only authentication type
encryptpwrw string[8~128] 6/6 Read/write password
encryptpwro string[8~128] 6/6 Read only password
encrypttyperw DES 6/6 Read/write encryption type
encrypttypero DES 6/6 Read only encryption type
rwcommunity string[31] 6/6 Read/write community
rocommunity string[31] 6/6 Ready only community
syslocation string[128] 6/6 Description of Camera location (Ex. Address)
syscontact string[128] 6/6 Description of Camera contactor (Ex. E-mail)