Vivotek IP8361 - Page 146

VIVOTEK
146 - User's Manual
UART transfer.
transmission_mode Tx,
Rx,
Both
0/7 Indicate transmission mode of the machine:
TX = server, Rx = receiver box, Both = DVR.
network_wire <boolean> 0/7 Indicate whether to support Ethernet.
network_wireless <boolean> 0/7 Indicate whether to support wireless.
wireless_s802dot11
b
<boolean> 0/7 Indicate whether to support wireless
802.11b+.
wireless_s802dot11
g
<boolean> 0/7 Indicate whether to support wireless
802.11g.
wireless_beginchan
nel
1 ~ 14 0/7 Indicate the begin channel of wireless
network
wireless_endchanne
l
1 ~ 14 0/7 Indicate the end channel of wireless
network
wireless_encrypt_w
ep
<boolean> 0/7 Indicate whether to support wireless WEP.
wireless_encrypt_w
pa
<boolean> 0/7 Indicate whether to support wireless WPA.
wireless_encrypt_w
pa2
<boolean> 0/7 Indicate whether to support wireless WPA2.
derivative_brand <boolean> 0/7 Indicate whether to support the upgrade
function for the derivative brand. For
example, if the value is true, the VVTK
product can be upgraded to VVXX.
(TCVV<->TCXX is excepted)
npreset <positive integer> 0/7 Number of preset locations.
eptz <positive integer> 0/7 A 32-bit integer, each bit can be set
separately as follows:
Bit 0 => stream 1 supports ePTZ or not.
Bit 1 => stream 2 supports ePTZ or not.
The rest may be deduced by analogy
nanystream <positive integer> 0/7 number of any media stream per channel
iva <boolean> 0/7 Indicate whether to support Intelligent
Video analysis
ir <boolean> 0/7 Indicate whether to support IR led.
tampering <boolean> 0/7 Indicate whether to support tampering
detection.
adaptiverecording <boolean> 0/7 Indicate whether to support adaptive
recording