Vivotek IP8361 - Page 82

VIVOTEK
82 - User's Manual
Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, you will need to congure command buttons
to control the PTZ scanner. Click Custom Command to open the Custom Command page to set the
commands in the Control Settings session. Please refer to your PTZ scanner user's manual to enter the
commands in the following elds. Click Save to enable the settings and click Close to exit the page.
►The command buttons will be displayed on the main page:
►If you select DynaDome/SmartDOME, Lilin
PIH-7x00, Pelco D, Pelco P, or Samsung
scc643 protocol as the PTZ driver, the
Control Settings column will not be
displayed.
►For all PTZ drivers, a total of ve additional
command buttons can be congured.
NOTE: