Vivotek IP8362 - Page 136

VIVOTEK
136 - User's Manual
7.10 IR cut control
Group: ircutcontrol (capability.nvideoinprofile > 0)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
mode auto,
day,
night,
di,
schedule
<product
dependent>
6/6 Set IR cut control mode
daymodebegintime 00:00~23:59 6/6 Day mode begin time
daymodeendtime 00:00~23:59 6/6 Day mod end time
disableirled <boolean> 6/6 Enable/disable built-in IR LED.
bwmode <boolean> 6/6 Switch to B/W in night mode if enabled
sensitivity low,
normal,
high
6/6 Sensitivity of light sensor
7.11 Image setting per channel
Group: image_c<0~(n-1)> for n channel products
NAME VALUE SECURITY
(get/set)
DESCRIPTION
brightness -5~5 4/4 Adjust brightness of image according to mode settings.
saturation -5~5,100 4/4 Adjust saturation of image according to mode settings.
100 for saturation percentage mode.
saturationpercent 0~100 4/4 Adjust saturation value of percentage when
saturation=100
contrast -5 ~ 5 4/4 Adjust contrast of image according to mode settings.
sharpness -3~3,100 4/4 Adjust sharpness of image according to mode settings.
100 for sharpness percentage mode.
sharpnesspercent 0~100 4/4 Adjust sharpness value of percentage when
sharpness=100
gammacurve 0~100 4/4 Gamma curve.
lowlightmode <boolean> 4/4 Enable/disable low light mode.
profile_i0_enable <boolean> 4/4 Enable/disable this profile setting
profile_i0_policy day, 4/4 The mode which the profile is applied to.