Vivotek IP8362 - Page 70

VIVOTEK
70 - User's Manual
If you want to congure another sensor setting for day/night/schedule mode, please click
Prole
to open
the Prole Settings page as shown below.
Please follow the steps below to setup a prole:
1. Check
Enable and apply this prole
.
2. Select the applied mode: Day mode, Night mode, or Schedule mode. Please manually enter a range of
time if you choose Schedule mode.
3. Congure the settings in the following columns. Please refer to the last page for detailed information.
4. Click
Save
to enable the settings and click
Close
to exit the page.
2011/03/13 17:08:56