Vivotek IP8372 - Network Deployment and Setup; Internet Connection Setup

VIVOTEK
User's Manual - 13
Network Deployment
Setting up the Network Camera over the Internet
This section explains how to congure the Network Camera to an Internet connection.
1. If you have external devices such as sensors and alarms, connect them to the general I/O
terminal block.
2. Connect the camera to a switch via Ethernet cable.
3. Connect either the DC 12V or AC 24V power wires from the Network Camera to a power
outlet.
There are several ways to set up the Network Camera over the Internet. The rst way is to set
up the Network Camera behind a router. The second way is to utilize a static IP. The third way is
using PPPoE.
2
3
POWER
COLLISION
LINK
RECEIVE
PARTITION
1
2
3
4
5
Ethernet Switch