- 8 -
www.vivotek.com
will become lighted. Operating in either network mode, the green LED will flash every
second as heartbeat to indicate alive. If the red LED is blinking, please check the network
connections.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet
cable plug in the power adapter. If the LED turns out to be steady blue, go to next
paragraph “Software installation”. If the Ethernet is not available, Network Camera will
switch to wireless LAN mode.
To install in wireless LAN
If the Ethernet is not available while power on, the Network Camera will search for any
access point with the SSID “default”. Once any access point is found, the LED will turn
blue to wait for installation. If the network environment cannot meet the default settings,
install Network Camera in Ethernet to proceed with wireless LAN configuration.
To Next Page
Loading...
