Vivotek VS8100-v2 - PTZ > PTZ Settings

VIVOTEK
User's Manual - 87
PTZ > PTZ settings
This section explains how to control the Network Camera’s Pan/Tilt/Zoom operation.
Mechanical: Connect the Network Camera to a PTZ driver or scanner via the RS485
interface.
Mechanical PTZ Operation
RS485 Settings
Disable: Select this option to disable this function.
PTZ camera: Select this option to enable PTZ operation.
To utilize this feature, please connect the Network Camera to a PTZ driver or scanner via RS485
interface rst. Then you can congure the PTZ driver and RS485 port with the following settings.
VIVOTEK offers three PTZ drivers: DynaDome/SmartDOME, Lilin PIH-7x00, and Pelco D protocol.
If none of the above PTZ drivers is supported by your PTZ scanner, please select Custom camera
(scanner). Please refer to the user’s manual of your PTZ scanner to determine the Camera ID, PTZ
driver, and Port settings. The Camera ID is necessary to control multiple cameras. If you click Save to
enable this function, the camera control panel will be displayed on the main page. Please refer to the
illustration on page 91. .