VIZIO VW42L HDTV10A User Manual
Version 6/19/2007 14
www.VIZIO.com
2.2 Connecting Coaxial (RF)
2.2.1 Using Your Antenna or Digital Cable for DTV / TV
1. Turn off the power to the HDTV.
2. Connect the coaxial (RF) connector from your antenna or
digital cable (out-of-the-wall, not from the Cable Box) to
the DTV/TV CABLE/ANTENNA connector.
3. Turn on the power to the HDTV.
4. Select TV using the INPUT button on the remote or side of
the HDTV, or directly by pressing the TV button on the
Remote Control.
2.2.2 Using the Antenna or Cable through your VCR
1. Turn off the power to the HDTV and VCR.
2. Connect the “Output to TV”, “RF Out” or “Antenna Out”
connector on the rear of your VCR to the DTV/TV
CABLE/ANTENNA connector at the rear of the HDTV.
3. Turn on the power to the HDTV and VCR.
4. Select TV using the INPUT button on the remote or side of
the HDTV, or directly by pressing the TV button on the
Remote Control.
Note:
a) Not all digital TV broadcasts are High Definition (HD). Refer to the
program guides, or consult your cable, satellite or TV station operator.
b) Digital broadcasts are not available in all areas. Refer to
www.antennaweb.org
for detailed information.
c) Make sure the antenna and coaxial cable are correctly grounded.
d) For Professional antenna installation contact us at www.VIZIO.com
or
call 1-888-VIZIOCE (1-888-849-4623).
Note: If you have an off-air antenna or cable TV, connect
it to the “Antenna In” connector on the rear of your VCR.
To Next Page
Loading...
Need help?
General
