BVD-403x
BVD-403х VIZIT
A
С
V
P
L BVD-403VPL
BVD-403CPL
BVD-403x VIZIT-ML400(S) VIZIT-ML300
VIZIT-KTM600R VIZIT-KTM602R
VIZIT®
VIZIT-M
FEATURES
SAFETY INSTRUCTIONS
25V
Connect the grounding wire of the doorstation to the protective ground.
Doorstation is intended for operation in video doorphones (Comfort Series).
The following models are available:
Abbreviations used in the models names:
- audio doorstation;
- colour camera;
- B/W camera;
- Pinhole lens;
- Camera illumination: IR LEDs for
White LEDs for
Doorstation operates together with electromagnetic locks , .
The product is compatible with similar electromagnetic locks with 20-Ohm impedance and a built-in degaussing
module.
Electromechanical locks with 10-Ohm impedance can be used as well.
Electromagnetic lock should be used together with
Keys Controller or .
Subscriber devices are products:
- apartment handsets (UKPs);
- monitors of Series 400.
Calls to the subscriber by pressing the button.
A beep at the doorstation and apartment handset / monitor when the button is pressed.
Duplex intercom.
Door zone video monitoring.
Camera LED illumination
Door unlocking by pressing the button on the apartment handset / monitor.
A beep indicates door lock release.
The product does not contain voltage above .
Do not make any connections or repair when the power is on.
Take care not to spill any liquids or chemically active substances on the product. Switch the power supply off, before
cleaning the doorstation. Clean by wiping with dry soft cloth. Do not use any liquid cleaners, aerosol cleaners or abrasive
agents.
·
·
·
·
·
·
·
A
A
Figure 1 - Doorstation BVD-403x
5
Speaker
4
CALL button
3
Microphone
2
LEDs for illumination
1
Camera (for BVD-403CPL, VPL)
1
3
4
5
2
Model
B/W camera
BVD-403A
BVD-403CPL
Colour camera
Pinhole lens
BVD-403VPL
Illumination
for camera
To Next Page
Need help?
General
