EasyManua.ls Logo

Vmed Technology BF2 - Battery Charging Information; Technical Specifications

Vmed Technology BF2
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
Maintenance
There are no field serviceable components inside the Vet-Dop2. Opening the housing
voids the warranty. Store this device in the storage pouch when not in use.
Charging the Battery
The Vet-Dop2 uses a rechargeable lithium-ion battery that has a useful life of
approximately two to four years. When the battery no longer holds a charge, battery
replacement may be required. (NOTE: Call for support concerning battery replacement.)
A full battery charge can take up to 4.5 hours depending upon how depleted the battery
charge is to begin with. The Vet-Dop2 can not be operated when the charger is plugged
in so only charge the battery when the device is not in use.
Specifications
TYPE: CW ultrasonic Doppler blood flow detector
CONSTRUCTION: High impact ABS-PC
DIMENSIONS (OVERALL): 6"x 4.625"x 1.75"
WEIGHT: 15 oz.
DOPPLER FREQUENCY: 9.6 MHz
AUDIO OUTPUT: Speaker and headset jack with speaker cutoff
CHARGER: Input: 110/220 VAC 50 or 60 Hz
Output: 5 VDC (Will not operate unit while charger is connected)
BATTERY: Rechargeable Lithium-ion
BATTERY USE BETWEEN CHARGES: 35-40 hours continuous
TRANSDUCER: Focused piezoelectric elements with 5 Ft. Cable
TRANSDUCER DIMENSIONS: 0.6" X 0.5" X 0.24"
CONNECTOR: 5 Pin circular DIN
SPHYGMOMANOMETER: 0-300 mmHg certified manometer with bulb type
pump and
deflation valve
HEADPHONES: Stereo audio with 3.5 mm phone plug
CUFFS: 6 ea. for limb circumferences 3.3-16.8 cm