VMI Northstar E Manual Conversion - Ramp Deployment and Stowing

northStar e™ ramP oPeratIon
8
WARNING
Vehicle should not be driven
with ramp deployed as serious
damage to vehicle, ramp,
passenger or property could
occur.
STOW NORTHSTAR E™ RAMP
1. Grasp ramp handle and lift ramp off the
ground.
2. Using the ramp handle, pull ramp into
the vehicle until it is fully retracted.
3. Manually close passenger rear door.
4. Manually close passenger front door.
DEPLOY NORTHSTAR E™ RAMP
1. Manually open the passenger front
door.
2. Manually open the passenger rear door
to full open position by using the door
handle pictured below.
3. Grasp ramp handle and pull outward.
4. Continue pulling ramp outward until it
is fully extended.
5. Using the ramp handle, gently lay ramp
on the ground.
WARNING
The passenger side rear door
must be closed before the front
door. Closing the front door rst
will cause damage to the vehicle.
WARNING
Do not bear weight on the
passenger side rear door.