Infinite X
Page 8
Reference Manual
Notes
Bridge Mode
Parallel Switch
VSP Velocity Sense Protection (limit)
Connect to input 1 only and use the two CH1 speakon outputs.
Use +1 for signal + and +2 for signal - The minimum impedance in bridge mode must
be 4 ohms. The amplifier is mono when running in bridge mode and both CH1 speakons
output the same signal.
Input 1 is linked to input 2. Connect to input 1 or input 2, the same signal will output from
both CH1 and CH2 outputs. Each channels level is set with its own level control.
Note that parallel operation on Infinite X amplifiers is not like the parallel mode on some
amplifiers that allow you to drive into very low impedances. Parallel mode on Infinite X
series amplifiers makes both inputs receive the same signal.
All Infinite X amplifiers are equipped with velocity sensing protection.
The VSP circuit monitors back EMF and will attenuate the output for a very brief period if
the amplifier detects over excursion or potential damage to a speaker.
If very severe overload conditions are detected and speaker failure is imminent, the
amplifier will mute its output for a brief period. Reducing the amplifiers output level will
stop the protection circuit from muting the output in this situation.
Please note that the VSP circuit can only assist with protecting your speakers.
It in no way guarantees complete protection against any component failure and safe
working practices should always be followed with regard to matching amplifier output
levels to speaker input ratings.
To Next Page
Loading...
Need help?
General
