6
PLAYING MP3’S FROM A USB FLASH DRIVE OR SD CARD
1. Switch the power on.
2. Insert USB flash disk or SD card into the slot. The music stored will be played automatically.
3. Music tracks can be selected with the control buttons on the speaker.
Press the Next Track / Previous Track Buttons to select songs you would like to play.
4. To fast forward to a song section, press and hold the
Fast-Forward Button while scrolling to
your desired section. To rewind to a song section, press and hold the
Rewind Button to scroll
back to your desired section.
5. Press the Play / Pause Button to play or pause the music.
6. Press and hold the Next Track / Volume Up or Previous Track / Volume Down Buttons on the
speaker to adjust the volume as preferred.
Note: In Bluetooth Mode, inserting a USB flash disk will disconnect the Bluetooth and switch to
playing from the USB flash disk. Press the M Mode Button to switch back to Bluetooth Mode.
LOCATING THE BLUETOOTH MENU
iPhone, iPad, and iPod Touch
a) On your device, go to Settings.
b) Select Bluetooth. If Bluetooth is not on, turn it on.
c) The iPhone / iPad / iPod will automatically search for new devices
Android™ Phones and Tablets
a) On your device, go to the Settings Menu.
b) Select Bluetooth (on older Android devices Bluetooth is found in the Wireless & Networks Menu).
If Bluetooth is not on, turn it on.
c) Select “Search for devices” if your phone or tablet does not automatically search for new devices.
Note: If you are unsure on how to access your Bluetooth Menu on your device, please refer to your
device’s instruction manual.
FM RADIO
1. Use the provided audio cable as an antenna to receive a good FM radio signal.
2. Once the device has been turned on, press the M Mode Button to cycle to FM Radio Mode.
3. Use the Play / Pause and FM Auto Scan Button to search for all available FM channels and store
them automatically.
4. To navigate between radio stations, press the Next Track / Volume Up or Previous Track /
Volume Down Buttons to select radio stations.
Note: Inserting the audio cable while the speaker is in FM Mode, will cause the speaker to
automatically switch to Aux Mode. Pressing the M Mode Button again will cycle back to FM Mode.