01-169
Automatic test sequence
The automatic test sequence checks all the
Diagnostic Trouble Codes (DTC) memories of
the control modules.
- Switch on ignition.
nosic HELP
1 - Rapid data transfer1
Indicated on display:
1)
Is displayed alternately
- Press key -1- for "Rapid data transfer" operating
mode.
- Switch on printer with the Print key (indicator
lamp in key lights up).
Rapid data transfer HELP
Select function XX
Indicated on display:
- Press key -0- twice; 00 to enter "Check
automatic test sequence" function.
- Confirm entry with Q key.
032906026BI 1.6l R4 MONO 1.3 D1 TEV
Codin
00002 WSC XXXXX
The V.A.G 1551 scan tool will show the engine
control module identification is displayed first e.g.
Thereafter all control module identifications with
eventual DTC memory entries are displayed.
Ст
. 11 из 129On Board Dia