– Press complete bonding surface of seal -3- on door -1- all
around using roller - 3356- .
– To do this, push the seal aside -arrow a- so that the roller -
3356- runs directly over the contact surface of the seal.
The roller can apply the necessary force -arrow b- to the bonding
surface -2- only when procedure described above is followed.
– If the seal has stretched, cut seal to required length and press
on butt joint well.
– If seal -3- comes loose in small areas again, press seal on well
again using roller - 3356- .
Note
The door must not be closed for a period of 2 hours to ensure the door outer seal does not move or loosen
again.
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
2. Door components 123
To Next Page
Loading...
Need help?
General
