EasyManuals Logo

Volkswagen Transporter 2020 User Manual

Volkswagen Transporter 2020
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
3 Repair notes
WARNING
If the vehicle has been converted by ABT e-Line, it is possible
that the repair instructions provided below are no longer valid.
In this case, the workshop manual in ELSA Pro under the
tab “Superstructures and modifications” provided by ABT e-
Line must be observed and applied.
⇒ “3.1 Rules for cleanliness”, page 6
⇒ “3.2 General information”, page 6
⇒ “3.3 General repair instructions”, page 6
⇒ “3.4 Contact corrosion”, page 7
⇒ “3.5 Nuts and bolts”, page 7
⇒ “3.6 Routing and attachment of lines”, page 7
3.1 Rules for cleanliness
Even small amounts of contamination/soiling can lead to defects.
Therefore, observe the following rules for cleanliness when work‐
ing on the air conditioning system:
Seal open lines and connections immediately with clean plugs,
e.g. from engine bung set - VAS 6122- .
Place removed parts on a clean surface, and cover them over.
Use only lint-free cloths.
Carefully cover opened components or seal them if repairs
cannot be carried out immediately.
Install only clean parts; do not remove new parts from pack‐
aging until immediately before installing. Do not use parts that
have been stored outside their packaging (e.g. in tool boxes).
If system is open, do not work with compressed air.
Protect disconnected electrical connectors from dirt and water,
and reconnect them only when dry.
3.2 General information
The engine control unit has a self-diagnosis capability. Before
carrying out repairs and for fault finding, first read event mem‐
ory.
For trouble-free operation of electrical components, a voltage
of at least 11.5 volts is necessary.
Do not use sealants containing silicone. Particles of silicone
drawn into the engine will not be burnt in the engine and dam‐
age the lambda probe.
Vehicles are equipped with a crash fuel shut-off circuit. It re‐
duces the danger of a fire in a crash as the fuel pump is
switched off via the fuel pump relay.
The system also improves the starting characteristics of the
engine. When the driver door is opened, the fuel pump is ac‐
tivated for 2 seconds to build up pressure in the fuel system.
3.3 General repair instructions
Never attempt to repair any components of the auxiliary/supple‐
mentary heater. Defective components must be replaced with
Genuine parts.
Transporter 2020 ➤
Auxiliary heater - Edition 04.2020
6 Rep. gr.00 - Technical data

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Volkswagen Transporter 2020 and is the answer not in the manual?

Volkswagen Transporter 2020 Specifications

General IconGeneral
BrandVolkswagen
ModelTransporter 2020
CategoryAutomobile
LanguageEnglish

Related product manuals