– Disconnect electrical connector -1-.
– Release retaining clip -1- in area marked by -arrows-, and re‐
move it.
– Pull combination sensor -2- out of heater unit.
Installing
Install in reverse order of removal, observing the following:
– Rout wiring harness through nearest cooling fin.
Note
Make sure not to damage the wiring harness when inserting the
retaining clip.
7.12 Removing and installing combustion air
blower 2 - V385-
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1410A-
Removing
– Remove auxiliary air heater control unit - J604- ⇒ page 42 .
– Unscrew bolts -2-.
– Detach combustion air blower 2 - V385- -1- from heat ex‐
changer -3-.
Transporter 2020 ➤
Auxiliary heater - Edition 04.2020
7. Auxiliary air heater 47
To Next Page
Loading...
Need help?
General
