3
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: Do not operate unit near heat sources, open flame, or combustible vapors or gases.
CAUTION: • The Depart Mode feature of this unit is to be operated in unoccupied areas only. No people or pets should be in
the area
• Allow your Vollara Air & Surface Pro+ to warm to room temperature before operating; damage may result from
turning on a cold unit
SAVE THESE INSTRUCTIONS
Read this manual in its entirety before using your Vollara Air & Surface Pro+
• NEVER locate air cleaner where it may fall into a bathtub or other water container; to protect against electrical hazards, DO NOT
immerse in water or other liquids
• DO NOT touch the control panel or plug with a wet hand
• DO NOT run cord under carpeting; DO NOT cover cord with throw rugs, runners, or similar coverings; arrange cord away from
traffic area and where it will not be tripped over
• DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or
damage the air cleaner
• To prevent a possible fire, DO NOT block the air intakes or exhaust in any manner; DO NOT use on soft surfaces, like a bed, where
openings may become blocked
• To avoid fire or shock hazard, plug the unit directly into an electrical outlet
• To disconnect air cleaner, turn controls to OFF, then remove plug from outlet; pull firmly on the plug, DO NOT unplug by pulling
on the cord
• Always unplug the unit before moving or cleaning, or whenever the air cleaner is not in use
• DO NOT use outdoors or on wet surfaces
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit, doing so will void your warranty
• Connect to properly grounded outlets only
• To reduce the risk of electrical shock, do not change the plug in any way; do not use adaptors
WARNING: • When using electrical appliances, basic precautions should always be followed to reduce risk of fire, electric
shock, and injury to persons, including the following:
• Eye damage may result from directly viewing the light produced by the lamp used in this product; always turn
off & unplug unit before removing filters or bulbs
• Do not operate this unit without the Filter Assembly AND Back Cover installed
• Disconnect power cord before servicing
To Next Page
Loading...
