8
Periodic maintenance is required to ensure that your Vollara Air & Surface Pro+ operates properly. The unit will display a PERFORM
CLEANING reminder when it’s time to perform regular maintenance. If you are operating your unit in a severely polluted environment,
cleaning of the unit, Purifier Plate, ActivePure® Cell, and Filter Assembly should be done more frequently. Shown here are basic
procedures that should be carried out to keep your unit running at top performance.
For optimal performance, and to prevent damage not covered by your warranty, install the Optional HEPA Filter. Failure to perform
routine maintenance could adversely affect the proper function of the unit or cause it to fail prematurely.
NOTE: If a unit is returned for repair, and it is determined that neglect of the unit or unauthorized tampering with any mechanical or
electronic component of the unit caused the failure, VolIara reserves the right to void the product warranty. This will require the
owner to pay for any required repairs.
CLEANING THE CASE
Wipe the unit with a soft cloth dampened (not wet) with water. Do not use chemicals or solvents. Vacuum the Top and Rear Grills
periodically to remove any lint buildup.
CLEANING THE ACTIVEPURE® CELL
Remove the ActivePure® Cell and carefully vacuum accumulated lint Do not wash the ActivePure® Cell. Damage from water may result.
FILTER ASSEMBLY CLEANING
1. When visibly dirty, simply remove the rear Filter Assembly from the unit (see pages 7 - 8), and with a hand-held vacuum, remove
the heavy particulate. This method will extend the life of the Filter Assembly.
2. If the Filter Assembly can’t be cleaned by vacuuming, replace the Filter Assembly.
FILTER ASSEMBLY REPLACEMENT
Contact your VolIara Independent Business Owner for replacement filters. See pages 8 - 9 for removal and installation instructions.
NOTE: Filter Assembly life will vary based on the operating environment.
CLEANING THE PURIFIER PLATE
Remove the Filter Assembly (see page 9). Carefully remove the Purifier Plate from the card cage by grasping the middle of the edge
nearest to you, and slowly pull it straight out. If you are in an environment where there are fats, oils, or grease, such as in a kitchen, start
by cleaning with denatured alcohol and a soft bristle brush. This will cut the grease without leaving a residue.
For all applications - Clean with a mixture of one part water and one part ammonia to remove contaminants. Place the plate into a
shallow dish, and pour enough of the water/ ammonia solution into the dish to just cover plate. Allow the plate to soak for no more than
10 minutes.
Remove plate and scrub with a soft bristle brush. Rinse thoroughly. Let air-dry for 24 hours or use a blow dryer to dry thoroughly.
NOTE: Using a Purifier Plate that is NOT completely dry may damage the plate.
The unit will display a REPLACE PLATE message if the purification plate needs to be replaced.
CHANGING THE ACTIVEPURE® CELL
The ActivePure® Cell should be replaced when REPLACE ACTIVEPURE® CELL appears on the display, or twelve (12) months when
used continuously or two (2) years if used less than 12 hours a day, whichever comes first. To change the ActivePure® Cell, follow the
instructions on page 10.
CAUTION: • Damage may result from soaking the Purifier Plate longer than 10 minutes
• Damage may result from using a Purifier Plate when not completely dry
GENERAL MAINTENANCE
WARNING: Unplug the unit before performing any maintenance procedures.
To Next Page
Loading...
