1 Unscrew and remove the plug (1). Disconnect the
cable by pressing down the lock (2) and at the same
time wiggle the connector in a forward position.
2 Connect the switch (3) and fit the crank tool (4).
3 Press down the switch button (5) and keep it
pressed while carefully turning the crank tool.
IMPORTANT:
Do not force the crank tool beyond the end position,
it could damage the Electrical Rudder Actuator.
NOTICE! Do not use the crank tool while rampage.
In Case of Emergency
120 47712786 11-2022 © AB VOLVO PENTA
To Next Page
Loading...
