15
21. Mark the connecting rod and cap nearest the fly-
wheel with a peener. Peen as shown in Fig. 21.
22. Remove the main bearing caps and lubricating
oil pump.
The main bearing caps are marked with a 2 or 3.
The corresponding figures are punched into the
block. Replace the axial bearings 1. Check that
the guide 2 for the caps is in good condition. Lift
out the crankshaft.
23. Remove the centre nut and washer for the gear
wheel on the lubricating oil pump. The shaft is ta-
pered and the gear wheel sits on a key.
24. Remove the bolts (4) from the pump body cover
and lift off the cover. Clean the body and check
that the gears are in good condition. Replace da-
maged parts.
To Next Page
Loading...
