27
69. Fit the key for the flywheel and push on the fly-
wheel. Fit the thick washer and tighten up the
flywheel with the nut. Tightening torque = 180
Nm (18 kpm = 130 lbftf). Use a counterhold
through the flywheel.
70. Oil the oil filter rubber gasket. Fit the oil filter and
the oil pressure contact. Screw in the oil filter so
far that the rubber gasket just touches the
engine. Then screw tight a further half turn.
IMPORTANT! Screw by hand.
71. MD6A. Install the stars generator with its
bracket. Screw tight the tensioning bar to the
engine. Earlier engines have a washer placed
between the engine and bracket.
MD7A. Install the alternator with its bracket.
Screw tight the tensioning bar to the engine.
72. Install the exhaust manifold. Fit a new gasket.
Check to make sure that the rubber hose for the
cooling water is in good condition. Fit the cooling
water hose from the cooling water pump and
tighten up the hose clamp.
To Next Page
Loading...
