24
1
2
3
KAD 42 31, 42
Check every 50 hours
Check every 100 hours or at least once every season
Check the sea water filter
Loosen the cover (1) and remove the sealing plate
(2), then lift out the insert (3). Shake out the insert
and flush it clean. Note! Check and clean more of-
ten when the boat is operated in waters containing
considerable amounts ofsediment, contaminants or
barnacles. Risk of clogging and overheating.
WARNING! Avoid water penetration.
Lubrication of steering shaft bearing
Lubricate the steering-shaft bearing with a grease gun.
Use water-resistant grease. Press grease in until it
emerges by the bearing.
Changing engine oil
Run engine until warm. Stop the engine and suck up
the oil through the tube for the dipstick. Change the oil
filter and top up with oil to the right level. Oil type - see
“Technical Data”.
WARNING! Hot oil can cause burns.
Changing the oil filter
The oil filter is replaced for the first time after 20 hours
and then every 100 hours.
Coat the rubber gasket on the new filter lightly with oil.
Screw the filter onto the contact surface and then
another half turn, no more. Check for leakage.
NOTE! The oil filter contains oil, dispose of it in a way
that will not harm the environment.
To Next Page
Loading...
Need help?
General
