Technical Data
66
Cooling system
Freshwater system capacity including heat
exchanger, approx.............................................. 34 liters (9.0 US gals)
Electrical system
System voltage ................................................... 24V
AC generator,
voltage/max. amperage ................................... 28V/60A
output, approx. ................................................ 1700W
Alternative generator equipment (accessory):
voltage/max. amperage ................................... 28V/100A
output, approx. ................................................ 2800W
Battery capacity .................................................. 2 connected in series 12V, max. 143 Ah
Battery electrolyte density at +25°C (77°F):
fully charged battery ........................................ 1.28 g/cm
3
= 0.0462 lb/in
3
(1.24 g/cm
3
= 0.0448 lb/in
3
)*
battery recharged at ........................................ 1.24 g/cm
3
= 0.0448 lb/in
3
(1.20 g/cm
3
= 0.0434 lb/in
3
)*
* Note. Applies to batteries with tropical acid.
Fuel system
Injection pump, setting:
TAMD74A-A ........................................................ 15° ±0.5° BTDC.
TAMD74A-B ........................................................ 12° ±0.5° BTDC.
Fuel specification
The fuel must comply with national and international standards for commercially supplied fuels,
such as:
EN 590 (with national environment and cold requirements)
ASTM D 975 No 1-D and 2-D
JIS KK 2204
Sulfur content: Complying with legal requirements in each country.
Low density fuel (urban diesel in Sweden and city diesel in Finland) can cause a loss of up to 5% of power and an
increase in fuel consumption of about 2–3%.
To Next Page
Loading...