Need help?Do you have a question about the Volvo Penta TAMD72A and is the answer not in the manual?
General| Fuel System | Direct injection |
|---|---|
| Aspiration | Turbocharged and Aftercooled |
| Bore | 108 mm |
| Stroke | 130 mm |
| Governor Type | Mechanical |
| Cylinders | 6 |
| Configuration | Inline |
| Engine Type | Diesel |
| Cooling System | Heat exchanger |
| Type | Inboard marine engine |
Specific safety rules for handling fluorocarbon rubber, including precautions against hydrofluoric acid formation.
Specifies torque values for various unions and fasteners, including standard values.
Step-by-step instructions for removing and preparing the cylinder head for overhaul.
Instructions for assembling the cylinder head, including valve springs, seals, and tightening sequences.
Guidance on renovating the cylinder block, including piston and connecting rod removal procedures.
Instructions for removing pistons and connecting rods from the cylinder block, including safety notes.
Step-by-step guide for assembling pistons onto connecting rods and installing them into the engine.
Instructions for installing new or renovated cylinder liners, including seal ring procedures.
Detailed steps for disassembling the engine's timing gear system and associated components.
Instructions for correctly assembling the timing gears, ensuring proper alignment and torques.
Step-by-step guide for safely removing the crankshaft from the engine block.
Detailed instructions for installing the crankshaft, including bearing shells, caps, and torquing.
To Next Page