101
Service and Maintenance
3. Moisten the rubber gaskets on the new filter elements
with oil. Screw on the elements by hand until the gaskets
make contact with the sealing surfaces. Then, turn a fur-
ther 1/2 to 3/4 of a revolution.
4. Fill with oil and start the engine. Check the tightness
around the filters.
NB! The filters must not be cleaned – replacement is the
only measure that may be taken.
Filling oil and checking level
Engine oil is filled through the oil reservoir filler pipe.
After oil changes and other maintenance, check the level of
the oil in the oil reservoir level glass. It should be between
the MAX and MIN markings. The check should be carried
out with the engine idling.
Fill to MAX level when changing oil.
A continuous check of the oil level is carried out while driv-
ing using the oil level warning light.
Temperatures refer to constant ambient temperatures.
-22 -4 14 32 50 68 86 104
-30 -20 -10 0 10 20 30 40
SAE 10W/30
SAE 15W/40
SAE 10W/40 2)
SAE 5W/30 1)
SAE 5W/40 2)
F
C
SAE 30
SAE 40
1) Fully synthetic and/or VDS/VDS-2 oil.
2) VDS-2 oil only.
To Next Page
