14
Instruments and controls
Feed switch and start/stop buttons
Certain buses have pushbuttons for start/stop and a feed
switch for the power supply instead of a starter switch and a
light switch. The feed switch and start/stop buttons are locat-
ed with the light switch at the bottom of the dashboard on the
left-hand side of the steering column.
The feed switch is a knob with 6 different positions:
Destination sign lighting
Neutral position
Check position for indicator and warning lights
Drive Day running lights on
Parking light on
Main/dipped beam on
P
O
C
1
P
Start button Feed switch Stop button
Activate Indicator lamp
Starting heater
When the button is pressed in, only one impulse is needed,
the starting heater (pre-heating) will be connected and the
indicator lamp comes on.
The amount of time that the starting heater is connected is
controlled by the coolant temperature.
See the chapter on start of engine for information on the
starting procedure,
To Next Page
Loading...
