3
– Remember it requires special knowledge, access to information and special
tools to be able to carry out reliable repairs.
– Never crawl under the bus if it is only supported by a jack. Use approved vehi-
cle supports or a solid pallet in case of punctures or wheel changes. Lifting
device should stand on a horizontal surface. The wheels which are not to be
lifted should be blocked so as to ensure that vehicle will not begin to roll.
– Retighten the wheel nuts after approximately 200 km if the wheel has been re-
moved.
– Tighten the wheel nuts every 6 months regardless of whether the wheels have
been removed or not.
– Observe that the bus tyres and rims should be approved for the intended load
and speed in accordance with the current laws.
– Be observant of exhaust and fuel smells. Possible leaks should be immediate-
ly taken care of at the garage.
– Besides on these pages, information of special importance to safety can
also be found in other places in this manual. Such information is marked
in the following way:
This warning stresses that an accident will occur or may occur
if the instructions are not followed. An accident can cause personal
injuries, possible deaths or serious damage to property.
Warning!
To Next Page
Loading...
