69
Block the bus wheels or connect the drawbar to
the tow truck.
Check before releasing the handbrake that the
bus can not start rolling!
If anything happens
Mechanical release of handbrake
1. Always start by blocking the wheels or by connecting the
drawbar to the tow truck, so that the bus can not start roll-
ing when the brake is released.
2. There is a screw located on both the drive shaft brake
cylinders behind a plastic cap. They should be un-
screwed until the brakes release. Use the intended
spanner from the toolkit or a 24 mm socket and ratchet
spanner. Count the number of rotations, this will make
resetting easier.
3. The bus can now be towed. Observe that towing in this
case must be done with a drawbar or similar since the
bus is totally without brakes.
4. Don’t forget to reset the screws to their original posi-
tion and to put on the plastic caps when towing is fin-
ished!
Mechanical release of handbrake
When the handbrake is released mechanically, the bus
can not be braked with the footbrake or the handbrake.
The drawbar must therefore be used when towing in this
instance!
Warning!
Warning!
To Next Page
Loading...
