88
Clearing fault codes after performed measures
– Turn the starter key to position ”0”.
– Keep the diagnostic switch pushed in while at the same
time turning the starter key to the drive position. Do not
release the switch.
– Keep it pushed in for approximately 3 seconds. Release
the switch.
Inspection
– From the drive position, turn the starter key to position
”0” and then back again to the drive position. The follow-
ing information will now be provided by the diagnostic
system.
Diagnostic lamp Fault code indicated
on constantly when diagnostic
switch pushed in
Starter key in drive,
engine stationary Yes 3 and 4
After brake check No 4
After engine start No No fault code
When the engine has been started and the brake check
performed, the diagnostic lamp should be off
R
R
1
2
3
0
1
2
3
0
R
R
1
2
3
0
1
2
3
0
If anything happens
To Next Page
