Volvo EC15E - Page 35

→ Flash Code 1 (armed): Still logged in within 15
min. elapse time after ignition off. Go to step 3.
→ Flash Code 11 (monitoring): Log in with key
combination for 4-digit User Code as shown.
3 You can start the engine now.
NOTE!
When a wrong User Code is used 5 times, the
Immobiliser System will be locked for 10 minutes.
The lock-out time will not be reset by switching off
power for the A-ECU. The correct 4-digit User Code
will reset the counter.
7. Deleting all 4-digit User Codes
NOTE!
Changing the 6-digit Master Code also deletes all
4-digit User Codes (see item 8).
1 Insert ignition key into ignition switch and turn it
to running position (position 1).
2 Log in with key combination for 6-digit Master
Code as shown.
→ Flash Code 4 (program mode) appears.
3 Repeat step 2.
4
Press
EXT
and
F2
.
→ Flash Code 8 appears (all codes deleted).
8. Changing 6-digit Master Code with
F1
NOTE!
All saved 4-digit User Codes will be deleted when
the 6-digit Master Code is changed!
1 Precondition: Master Code programmed.
2 Insert ignition key into ignition switch and turn it
to running position (position 1).
→ Flash Code 11 (monitoring)
3 Enter key combination to change 6-digit Master
Code as shown.
4 Enter key combination for NEW 6-digit Master
Code as shown.
5 Repeat step 4 to confirm.
→ Flash Code 2 (code stored/accepted)
appears.
6 You can program new 4-digit User Code(s) now
(see item 5.).
MD
XXXXXX
ENT
V1178591
Key combination for 6-digit Master Code
EXT
F2
V1178593
Key combination to delete all codes
F1
XXXXXX
ENT
V1178590
Key combination to change 6-digit
Master Code
MD
XXXXXX
ENT
V1178591
Key combination for NEW 6-digit Master
Code
Instrument panels
Instrument panel, left 33