4 To close the Attachment Quick Coupler, return
the switch to position
Neutral
(B).
NOTE!
Before finishing the process, the correct lock has to
be checked outside the machine directly at the
Attachment Quick Coupler.
5 To confirm the correct lock and to finish the
process:
Press down the lower end of the switch (A) and
release.
→ The process is finished, when the illuminations
and the beep end.
2. Switch for automatic engine speed control
— auto idle
(optional, not for EC15E)
Operation activates the automatic engine speed
control. The throttle lever may remain in any
desired position. With stopping the work load the
automatic engine speed control reduces the
engine speed to idle speed level after approx. 5
seconds
When operating a control lever the engine speed
will rise again up to the speed level set by the
throttle lever
3a. Switch for automatic shutdown
(optional, not for EC15E)
Press lower end of switch = automatic shutdown
is off
Switch in middle position = engine will shut down
after 2 minutes of inactivity
Press upper end of switch = engine will shut down
after 10 minutes of inactivity
NOTE!
A countdown sound signal of around 10 beeps will
appear before shutdown
To restart, the ignition switch must first be put in
pos. 0. See also point 4.
3b. Switch for attachment (optional)
If not assigned here, you can use the front button
on the right lever, read chapter
Controls
on page
45
.)
To Next Page
Loading...
